How to Install Mega Bird Spikes

by Alex A. Kecskes

Some warehouses, airplane hangars, marinas, dumpsites, and other structures or buildings near lakes and coastal areas are acutely vulnerable to very large pest birds. Without proper bird control measures to deter them, these large birds can cause considerable damage to rooftop A.C. units, skylights, sliding doors and rooftop ventilators and many other areas.

If your property is being besieged by really large birds like larger pigeons, seagulls, cormorants, vultures, raptors and the like, you may want to look into getting the Mega Spike. Like Gutter Spikes, these marine-grade stainless steel spikes are built into a U.V. protected polycarbonate base. The big difference is that these bird spikes have long, 7-inch spikes and will cover a 3- to 7-inch area.

Mega Bird Spikes can be used in light to heavy pressure situations. Heavy pressure areas will have lots of birds nesting or roosting at the site with a food or water source nearby. Medium Pressure is often a food or afternoon resting site, but not used for nesting or roosting. Light Pressure sites offer no food or shelter and birds stop only briefly during the day.

Before installing Mega Spikes, make sure that the surface is clean and dry. When cleaning out bird droppings, feathers and nests, be sure to wear Proper Protective Equipment (PPE) like eye and respiratory protection, as bird debris can carry any of 60 known diseases.

Install the spikes on ledges, I-beams, parapet walls, conduits and pipes--on flat or curved surfaces--wherever pest birds are most likely to gather. Mega spikes come in convenient 2-foot lengths to make installation simple. When installing the spikes, the width of the spikes should protect the surface, leaving no more than a 1-inch gap on either side. To attach the spike, use glue, screws, or tie it down to the surface using common hose clamps, nylon ties or wire lashings. If you intend to glue the spikes in place, apply construction-grade adhesives (available at most hardware stores). And make sure you use a high elasticity U.V.-resistant sealant that stands up to weather extremes (40 to 170 degrees F). You can get this sealant in a variety of colors—like black, gray and white.

For additional advice on how to properly install bird spikes, consult an expert like the folks at Bird-B-Gone.

Related articles

• How to Install Bird Spikes (how-to-install-bird-spikes.com)
• Effective Pigeon Control Methods (birdcontrolproducts.blogetery.com)
• Bird Proof Your Strip Mall with Bird Spikes (birdspikesnow.blogetery.com)

Brainy Birds Get the Point

By Terra Anders

Being called a “bird brain” is not necessarily an insult.  The proper response might be, “Which bird?”  Scientists have studied this very topic; the size of birds’ brains in relation to the intelligent behavior that they exhibit.  Those who are waging a battle to get rid of birds on their roofs or rafters should take heed.  They may not be dealing with idiots. 

While admittedly the definition of intelligence itself is still controversial among the scientific experts, the study of how birds display intelligent behavior is based almost entirely on observational conclusions.  Still, observing is one of the fundamental scientific tools for any scientist, so it does seem to hold at least some weight.  Anyone considering bird prevention on property and structures must take into account the kind of bird that is causing the problem.

In his efforts to further define exactly what intelligence is, behavioral scientist, Louis Lefebvre, spent some time on researching birds and their ability to innovate.  In this case, he defined innovation as the ability to adapt to changing or different challenges.  Most of the studies revealed that birds seem to be most innovative when it comes to where to live and how to get their next meal.  Bird lovers around the globe have reported amazing bird behavior, and Lefebvre studied these reports to determine if we could learn anything new about human intelligence from these so-called “bird brain” activities. The information from this study also helps us understand how to more effectively adapt our own bird removal techniques.

How to Install Bird Spikes

by Alex A. Kecskes
Larger pest birds like pigeons, crows or gulls love to gather in the many nooks and crannies of a structure or building. They’ll land on signs, rooftops and windowsills to roost and nest, creating quite a mess. A single pigeon, for example, can excrete up to 25 pounds of droppings every year. Federal, state and local wildlife protection ordinances forbid the use of lethal or harmful bird control measures against many types of birds. So what can you do?
Increasingly, many facilities and property managers have installed one of the most popular and effective bird control measures on the market—the Bird Spike. These humane bird proofing devices are widely used throughout the world. And they’re now available in a variety of types, sizes and colors.
For example, there’s the Stainless Steel bird spike. It’s ideal for use in Light to Heavy Bird Pressure environments—in both enclosed or exposed areas. Bird pressure is basically defined as how determined a bird is to remain in the area. Heavy pressure areas will have lots of birds nesting or roosting at the site with a food or water source nearby. Medium Pressure is often a food or afternoon resting site, but not used for nesting or roosting. Light Pressure sites offer no food or shelter and birds stop only briefly during the day.
Bird spikes should be installed on ledges, I-beams, parapet walls, conduits and signs--on flat or curved surfaces. Stainless steel spikes come in rows of spiked strips in 3-, 5- and 8-inch widths and two-foot sections. The 3-inch spikes will provide 2 to 4 inches of coverage on a 5-inch wide ledge; the 5-inch spikes will cover 5 to 7-inches on a 7-inch wide ledge; and the 8-inch spikes will cover 8 to 10 inches on a 10-inch wide ledge. One manufacturer offers a stainless steel spike with a patented “bend-and-crush” design for permanent installations. It features up to 40 spikes per foot in a linear array. The unique “no-nest” design features no-gap spacing to deter birds from roosting or landing.
To properly install stainless steel bird spikes, the surface should be clean and dry. The width of the spikes should protect the surface leaving no more than a 1-inch gap on either side. To attach the spike, use glue, screws or tie it down to the surface. For pipes and conduits, use a 1-inch spike to cover 1 to 2 inches. To install them, use common hose clamps, nylon ties or wire lashings.
Bird spikes also come in rigid U.V.-resistant unbreakable polycarbonate and are ideal for deterring pigeons, seagulls or larger birds in Light to Heavy Bird Pressure areas. Plastic bird spikes can be used around cell phone antennas and other radio frequency aerials without concerns over RF interference. These spikes come in rows of spiked strips in 3-, 5- and 7-inch widths and two-foot sections. The 3-inch spikes will provide 1 to 5 inches of coverage on a 5-inch wide ledge; the 5-inch spikes will cover 5 to 7-inches on a 7-inch wide ledge; and the 7-inch spikes will cover 6 to 9 inches on a 9-inch wide ledge.
Another advantage of plastic bird spikes is that they come in 7 colors to match their surroundings. Like stainless steel spikes, poly spikes can be glued, screwed or tied down to most any surface. For gluing, apply construction-grade adhesives (available at most hardware stores) in the glue trough. Use the offset pre-drilled holes for screws or glue. And take advantage of the breakaway notches if you need smaller pieces.

Related articles

• Get Rid of Birds with Stainless Steel Bird Spikes (birdspikesnow.blogetery.com)
• How to Keep Birds Off Windowsills and Rooflines (birdrepellents.blog.com)
• Get Rid of Pigeons with Pigeon Spikes (pigeoncontrol.blog.com)

Get Rid of Birds with Stainless Steel Bird Spikes

by Fran Prisco
Pest birds have caused a lot of problems for building managers and homeowners alike.  Their landing, nesting and roosting on roofs, building ledges and parapet walls have accounted for thousands of dollars in damages.  Bird droppings are acidic and can quickly degrade building materials.  The droppings also can carry any of 60+ communicable diseases.  Slip and fall hazards are another issue facing building owners from bird droppings on sidewalks and walkways.
Problem:  Pigeons are gathering at dusk on the roof of a retail shopping center.  They are not only landing on the ledges and parapet walls, but they have begun to build their nests in channel letters on the walls and other protected areas of the building.  Storeowners and customers have started to complain to the property management company about the build up of bird droppings on the storefronts and walkways.
Solution:  Install stainless steel bird spikes.  The first step is to be sure that the surface to which the bird spikes will be attached is clean of all droppings and debris.  It is best to power wash the surface if possible, otherwise, be sure that the droppings are wet before removing them.  Dry bird droppings can be breathed in and be dangerous.  Once the area is clean, it is time to install the bird control spikes.
Stainless steel bird spikes are ideal to use on shopping centers and other business and historical buildings.  Once installed they are virtually invisible, thus not taking away from a building’s architectural design.  The spikes are easily installed using glue, screws or zip ties.  The spikes come in two-foot sections for quick installation.  Stainless steel bird spikes are perfect for use in areas that are close to the ocean as they will not rust or deteriorate in the sun. 
When installing any type of bird control system, it is important that the job is done correctly.  It is often best to have a professional bird control installer do the job.  Manufacturers of bird control products can often suggest the right person or company to get the job done right.

Related articles

• How to Prevent Birds from Nesting (how-to-get-rid-of-birds.com)
• How to Keep Birds Off Windowsills and Rooflines (birdcontrolproducts.blogetery.com)
• Bird Proofing Commercial Office Buildings (birdcontrolproducts.blog.com)
• Get Rid of Birds with Bird Deterrents (birddeterrentsnow.blog.com)
• Get Rid of Pigeons with Pigeon Spikes (pigeoncontrol.blog.com)

How to Install Gutter Bird Spikes

by Alex A. Kecskes

Whether you’re the facilities manager of a large building or a homeowner, you’ll want to keep the maintenance and repair costs of your building down to a minimum, especially in these hard times.

One major headache encountered by many property owners is clogged gutters. And one of the main ways gutters become clogged is bird debris--feathers, nesting materials, bird droppings, even dead birds. Without effective bird control measures, clogged gutters can cause water to seep underneath roofing tiles to eventually cause leaks. Using poisons or firearms and similar tactics can be a problem, not the least of which is that many birds are protected by federal, state and local laws.

The only viable solution is humane bird control.  In the case of gutters, many property owners have elected to use Gutter Bird Spikes. They’re ideal for deterring pigeons, seagulls and other larger birds in light to medium bird pressure areas. (Medium pressure is often used by pest birds as a food or afternoon resting site, but not for nesting or roosting; light pressure sites offer no food or shelter and birds stop only briefly during the day.)

Prior to installing Gutter Spikes, make sure that the surface is clean and dry. When cleaning out bird droppings, feathers and nests, be sure to wear Proper Protective Equipment (PPE) like eye and respiratory protection, as bird debris can carry any of 60 known diseases.

Gutter bird spikes generally come in 2-foot strip lengths and cover an area of 4 to 6 inches. They work by preventing pest birds from landing on gutter ledges and nesting in gutters. The best gutter spikes will fit any size gutter and don’t need separate clips or hardware to stay in place. You just attach them with simple thumbscrews. And once they’re installed, they’re virtually invisible. The best gutter spikes are built into a U.V. protected polycarbonate base.

For additional advice on how to properly install bird spikes, consult an expert like the folks at Bird-B-Gone.

Related articles

• Bird Proofing for Commercial Roofers (birdcontrolproducts.blogetery.com)
• Bird Proof Your Strip Mall with Bird Spikes (birdspikesnow.blogetery.com)
• Window Washing Companies Adding Bird Control (birdcontrolproducts.blog.com)
• Bird Proofing for Commercial Applications (howtogetridofbirdsfast.blog.com)